无锡科达移动脚手架厂家【官网】生产:【移动脚手架】【门式脚手架】【梯形脚手架

无锡科达脚手架生产厂家

示例图片三
网站首页 > 新闻资讯 > 时事新闻

关于大型离心风机运行使用方面的知识

2018-12-24 14:40:35 无锡科达脚手架生产厂家 阅读

前面关于离心风机的相关知识我们也讲了不少了,今天我们为大家来讲解一下关于大型离心风机在使用和运行方面的知识,关于本期的主要内容如下所示:(1)、大型离心风机试运转合格后,应在风机机壳表面包扎上隔热层,使用绝热材料,以便减少机壳对外的热传播,保护轴承的安全。而且,隔热层的厚度应控制好,还要能够方便检修和拆卸。

Previous knowledge about centrifugal fans has also been talked about a lot. Today, we will explain the knowledge about the use and operation of large centrifugal fans. The main contents of this period are as follows: (1) After the large centrifugal fans are qualified for commissioning, they should be coated with insulation layer on the surface of the fan casing and use insulation materials in order to reduce the heat transfer from the casing to the outside. Sow, protect the safety of bearings. Moreover, the thickness of the insulation layer should be well controlled, and it should be easy to repair and disassemble.

(2)、轴承的供油情况、振动情况以及轴承的温度,应经常进行检查,以便能够让风机能够正常运转。

(2) The oil supply, vibration and temperature of the bearing should be checked regularly so that the fan can operate normally.

(3)、大型离心风机刚刚开始工作时,轴承部位的振动是很小的,但是随着使用时间的增加,其振动会逐步增大。一旦达到风机的最大极限时,就要停机进行修理了,否则再继续使用的话,就会出现问题,发生危险,对风机造成损坏。

(3) When a large centrifugal fan is just starting to work, the vibration of bearing parts is very small, but with the increase of service time, its vibration will gradually increase. Once the maximum limit of the fan is reached, it is necessary to shut down and repair it. Otherwise, if it continues to be used, there will be problems, dangers and damage to the fan. 

辛苦整理!转载请注明来自 http://www.wxmlfj.com/faq/2099.html



标签:   脚手架 离心风机 脚手架厂家 梯形脚手架 门式脚手架 移动脚手架